![]() ![]() Power Supply: Internal, Universal Input, 10 Wįuse Type: 20mm x 5mm, Class 3 Slow - Blow. AES/wordclock clock present: led indicators.AES/wordclock source select: led indicators.Accuracy: 2ppm at all sample rates up to 768KHz, 0.1 Hz increments 48KHz sample rate.+/-%: Nominal sample rate with percent pull up/down indication for 32,44.1,48,96 & 192KHz.+/- ppm: nominal sample rate with +/- ppm error indication for 32,44.1,48,96 & 192KHz.Frequency: actual frequency up to >768KHz.4 of which are on the front panel for ease of connectivity.īlue/white LCD display wth three switchable modes of operation with mode led indicators for each: BNC wordclock outputs 20 x simultaneous re-buffered BNC wordclock outputs with 33 ohm output impedance.AES Output: with zero latency loopthrough from AES input.BNC Output: with zero latency loopthrough from input BNC.31st sunday of ordinary time year c, Melodia do salmo 22 23 karina, Vintage cars for rent. AES sync input: switchable 110ohm/hiz termination D touch international sdn bhd, Anna wu rubin thomlinson. ![]() BNC wordclock input: switchable 75ohm/hi z termination Features Include: 2 in x 20 out Clock Measurement and Distribution Amplifier. In electronics and especially synchronous digital circuits, a clock signal (historically also known as logic beat) is an electronic logic signal (voltage or current) which oscillates between a high and a low state at a constant frequency and is used like a metronome to synchronize actions of digital circuits.Using an audio signal to provide the clock means even products without a wordclock output, such as some analogue to digital converters, or one of the many mic pre-amplifiers with internal A/D conversion but no word clock output, can be the master wordclock source for the whole digital studio. The wordclock outputs can be fed from the wordclock input at any sample rate between 32KHz and 768KHz or derived from an AES11 input or stripped from an AES3 audio signal at any sample rate between 32KHz and 192KHz. Sixteen BNC clock outputs are situated on the rear panel with a further four BNC clock outputs on the front panel for quick patching to other digital devices. It has both AES/EBU and BNC word clock inputs featuring a zero latency loopthrough output with switchable high impedance to maintain the correct level of the digital signal for onward distribution. It uses a high stability TCXO (temperature compensated xtal oscillator) along with a microcontroller to measure the incoming sample rate to an accuracy of 2ppm and displays the information in three different formats, actual frequency (to one decimal place), nominal frequency +/- ppm error, or nominal frequency plus percentage of pull up or pull down. The Drawmer D-CLock is a dual input, twenty output word clock distributor providing a high accuracy reference measurement of the incoming sample rate.ĭigital audio facilities often require a number of clock sources, which are used to synchronise outboard processors to the system clock rate using external clock inputs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |